The iD2 has an Optical Input, letting you add up to 8 additional Inputs at 44.1/48kHz, 4 at 88.2/96 kHz and 2 at 176.4/192 kHz. This article will guide you through the process of configuring your iD2 to work with external devices.
To add additional inputs via ADAT, connect a good quality ADAT cable from the output of your external D/A C to the Optical In port on the iD2.
Before proceeding, ensure that your external pre-amp has been configured as the ‘Clock Master’ device - consult the operator’s manual for instructions on how to do this.
Now, with the iD2 connected to the computer, open iD Control and navigate to the Settings tab.
Then adjust the ‘Clock Source’ to Digital 1, via global settings. Ensure that the sample rate also matches the one set on your external pre-amp.
Once configured, you can monitor your digital inputs through the iD Control Mixer by raising ‘OPT’ channels 1-8.
To record these inputs in your DAW, create a new audio track for each digital input channel you are planning to use, and assign the relevant input to each audio track - these should appear as ‘ADAT 1-8’.